There are a few little bubbles around the edges of some of the holes, but you can clearly see the shark teeth and Gus likes that. It's hanging on the wall next to his bed.
| "G" with Shark Teeth |
|
My stepson, Gus, loves sharks. Well, sharks and dinosaurs. And snakes... and alligators. So one
of the little things I made him for his room was a letter G (for Gus, of course) with some shark teeth in it. I admit
that I did not cut the G myself; the pre-cut letters are pretty inexpensive at a hobby store, so I took the easy route on
that one. I just drilled some flat-bottomed holes in it using a forstner bit in my drill press. Then I put one
shark tooth in each hole and filled in the hole with epoxy.
There are a few little bubbles around the edges of some of the holes, but you can clearly see the shark teeth and Gus likes that. It's hanging on the wall next to his bed. |